12:20:28,507 - DEBUG - PostProcessingPlugin.PostProcessingPlugin._createView : Post processing view created. There were 150 ms between these two entries. 12:18:57,247 - WARNING - UM.Qt.QtApplication._onQmlWarning : file:///C:/Program Files/Ultimaker Cura 4.10.0/resources/qml/PrintSetupSelector/Custom/MenuButton.qml:42:18: QML Label: Cannot anchor to an item that isn't a parent or sibling. 12:18:57,098 - DEBUG - PostProcessingPlugin.PostProcessingPlugin._createView : Post processing view created. In cura.log, look at first startup, specifically these entries Second time I ran it normally and startup took minutes, stalling at “Loading UI”. So I’ve run two scenarios for comparison:įirst time, I ran Cura as administrator. I found that running Cura as an administrator is a workaround for the slow behavior. I erased my cura.log before doing this so my attached cura.log will be clean and only show the two startups that I did for comparison. I’m having significant delays running 4.10.0. (Extra information relevant to the issue.) To find the log file to upload, or copy a relevant snippet from it.) For big files you may need to use WeTransfer or similar file sharing sites. (For slicing bugs, provide a project which clearly shows the bug, by going to File->Save Project. (What should happen after the above steps have been followed.) The first time, it seems to spend significant time in 'loading machines' Takes ages to start - all in the splash/loading progress screen. (What happens after the above steps have been followed.) (Image showing the problem, perhaps before/after images.) Closed it, waited a few seconds, then started it again.Started cura for the first time since reboot.Include at least the operating system and maybe GPU.) (Information about the operating system the issue occurs on. (The version of the application this issue occurs with.)
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |